Homa T-motor voltage change Uživatelský manuál stáhnout pdf

T-Motor Voltage Change

This procedure will provide you with step by step instructions

to convert the operating voltage of dual voltage motors.

Publication

88FN2046A

Please Contact Technical Support At 203-736-8890 With Any Additional Questions

Please Be Prepared To Provide Pump Serial Number During Call

Page

1 of 2

1. Remove cap screws holding motor to

volute

2. Slowly, and carefully lift motor straight

up (Do not allow rotor to scrub against

stator!) Lift motor part way and

disconnect seal probe. Failure to

disconnect will cause the probe to

become damaged and rip out (Fig.1)

3. Remove wavy washer from upper

bearing and set it aside.

4. Turn motor over and gently untuck

wire bundles from around the stator

winding. (Fig. 2)

5. Record the wires in each of the

bundles. If there are 4 bundles, the

pump is wired for 230V. If there are 6

bundles, the pump is wired for 460V.

6. Identify and separate the bundle that

has wire number 1. Also separate any

bundles that have numbers 4, 5, and

6. (Fig. 3)

Fig. 1

Fig. 2

Fig. 3

1 2

T-Motor Voltage Change This procedure will provide you with step by step instructions to convert the operating voltage of dual voltage motors. P

7. Re-connect the wires as seen in (Fig. 4). 8. Separate the wire bundle with wire number 2 and re-connect as seen in (Fig 4). 9. Separate

Žádné komentáře

Homa T-motor voltage change Uživatelský manuál